Product ID:NUBRITE INTERIOR LATEX SEMI-GLOSS OFF WHITE, 311927
MSDS Date:05/25/1999
FSC:8010
NIIN:00N092247
Status Code:A
MSDS Number: CJRJW

Emergency Phone: 800-424-9300

Info Phone: 800-368-2076

Cage: 85520

Telephone: 800-368-2076

Cage: 85520

PROPYLENE GLYCOL

CAS: 57-55-6

RTECS: TY2000000

Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:REPORTS HAVE ASSOCIATED REPEATED AND
PROLONGED OCCUPATIONAL OVEREXPOSURE TO SOLVENTS WITH PERMANENT
BRAIN & NERVOUS SYSTEM DAMAGE. INTENTIONAL MISUSE BY DELIBERATELY
CONCENTRATING AND INHALING THE CON TENTS MAY BE HARMFUL OR FATAL.
DO NOT BREATHE VAPORS OR SPRAY MISTS. WEAR AN APPROPRIATE, PROPERLY
FITTTED RESPIRATOR (NIOSH APPROVED) DURING AND AFTER APPLICATION
UNLESS AIR MONITORING DEMONSTRATES V APOR/MIST LEVELS ARE BELOW
APPLICABLE LIMITS. FOLLOW RESPIRATOR MANUFACTURER'S DIRECTIONS FOR
RESPIRATOR USE. BASED ON THE PRESENCE OF PROPYLENE GLYCOL THIS
PRODUCT HAS LOW TOXICITY BUT IS READILY ABS ORBED AND CAN CARRY
(EFTS OF OVEREXP)
Effects of Overexposure:HLTH HAZ: OTHER MATERIALS THROUGH INTACT SKIN.
BASED ON THE PRESENCE OF PROPYLENE GLYCOL THIS PRODUCT MAY BE
HARMFUL IF IT IS SWALLOWED. BASED ON THE PRESENCE OF PROPYLENE
GLYCOL THIS PRODUCT CAN BE I RRITATING TO THE EYES. BASED ON THE
PRESENCE OF PROPYLENE GLYCOL THIS PRODUCT MAY CAUSE SKIN
IRRITATION.

First Aid:EYE: FLUSH WITH LUKE WARM WATER FOR AT LEAST 15 MINUTES. SEEK
PHYSICIAN IMMEDIATELY. SKIN: FLUSH WITH COPIOUS AMOUNTS OF LUKE
WARM WATER. REMOVE CONTAMINATED CLOTHING PROMPTLY. CONTACT A
PHYSICIAN IMM EDIATELY. INHALATION: REMOVE EXPOSED INDIVIDUAL TO
FRESH AIR. RESTORE BREATHING IF REQUIRED. CONTACT A PHYSICIAN
IMMEDIATELY. INGESTION: RINSE MOUTH IMMEDIATELY. GIVE EXPOSED
INDIVIDUAL 6 TO 8 OUNCES OF LIQUID. (NEVER GIVE ANYTHING BY MOUTH
TO AN UNCONSCIOUS PERSON.) DO NOT INDUCE VOMITING UNLESS ADVISED BY
A PHYSICIAN. CONTACT A PHYSICIAN IMMEDIATELY.

Extinguishing Media:MEDIA SUITABLE FOR SURROUNDING FIRE .
Fire Fighting Procedures:USE NIOSH APPROVED SCBA & FULL PROTECTIVE
EQUIPMENT .
Unusual Fire/Explosion Hazard:HEAT PROTECTION PROCEDURES: CONTAINERS
EXPOSED TO INTENSE HEAT FROM FIRES SHOULD BE COOLED WITH WATER TO
PREVENT VAPOR PRESSURE BUILDUP WHICH COULD RESULT IN CONTAINER
RUPTURE.

Spill Release Procedures:DO NOT FLUSH TO SEWER, WATERSHED, OR WATERWAY.

Handling and Storage Precautions:KEEP FROM FREEZING. DO NOT STORE ABOVE
120F. DO NOT TAKE INTERNALLY. CLOSE CONTAINER AFTER EACH USE. KEEP
OUT OF REACH OF CHILDREN.
Other Precautions:DIRECTION ADVISED: MANUFACTURER TAKES NO
RESPONSIBILITY FOR DETERMINING WHAT MEASURES ARE REQUIRED FOR
PERSONAL PROTECTION IN ANY SPECIFIC APPLICATION. THE GENERAL
INFORMATION GIVE SHOULD NBE USED WIT H DIRECTION.

Respiratory Protection:IN OUTDOOR/OPEN AREAS USE (NIOSH APPRVD) MECH
FILTER RESP TO REMOVE SOLID AIRBORNE PARTICLES OF OVERSPRAY DURING
SPRAY APPLICATION. IN RESTRICTED VENT AREAS USE (NIOSH APPRVD)
CHEM-MECH FILTERS DESIGN ED TO REMOVE COMBINATION OF PARTICULATE &
GAS & VAPOR. IN CONFINED AREAS USE (NIOSH APPRVD) AIR LINE TYPE
RESP/HOODS. RESP PROT MAY ALSO BE NEC IN ANY (SUPDAT)
Ventilation:USE VENT AS REQUIRED TO CONTROL VAP CONC. AVOID PRLNG/ RPTD
BRTHG OF VAP. IF EXPOS EXCEEDS TLV, USE NIOSH-APPRVD RESP TO PVNT
OVEREXP. (SUPDAT)
Protective Gloves:RESISTANT-NATURAL RUBBER, NEOPRENE, BUNA N OR
NITRILE.
Eye Protection:ANSI APPROVED CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:EYE WASH AND DELUGE SHOWER MEETING ANSI
DESIGN CRITERIA . AN APRON SHOULD BE WORN TO AVOID SKIN CONTACT.
Work Hygienic Practices:WASH HANDS THOROUGHLY BEFORE EATING AND USING
WASHROOM. REMOVE CONTAMINATED CLOTHING IMMEDIATELY AND DO NOT WEAR
IT UNTIL IT HAS BEEN PROPERLY LAUNDERED.
Supplemental Safety and Health
RESP PROT: LATER MFG OPERATIONS IN WHICH PROD MAY BECOME AIRBORNE IN
FOAM/VAP/DUST. VENT: PROVIDE GENERAL DILUTION/LOC EXHST VENT IN
VOLUME & PATTERN TO KEEP TLV OF MOST HAZS INGRED IN SECTION 2 BELOW
ACCEPTABLE LIMIT, LEL IN SECTION 5 BELOW STATED LIMIT, & TO REMOVE
DECOMP PROD DURING WELDING (OTHER INFO)

Boiling Pt:>100.C, 212.F
B.P. Text:212-490F
Vapor Pres:0.50 MMHG @ 68F
Vapor Density:HVR/AIR
Spec Gravity:1.22
VOC Grams/Liter:1.96
Evaporation Rate & Reference:SLOWER THAN BUTYL ACETATE
Percent Volatiles by Volume:70.54

Stability Indicator/Materials to Avoid:YES
THIS PRODUCT IS INCOMPATIBLE WITH STRONG ACIDS.
Hazardous Decomposition Products:MAY PRODUCE HAZARDOUS FUMES WHEN
HEATED TO DECOMPOSITION AS IN WELDING. FUMES MAY CONTAIN CARBON
MONOXIDE, CARBON DIOXIDE, AND OXIDES OF NITROGEN.
Conditions to Avoid Polymerization:WILL NOT OCCUR.

Waste Disposal Methods:DISPOSE OF PRODUCT IN ACCORDANCE WITH APPLICABLE
LOCAL, COUNTY, STATE, AND FEDERAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.

SARA Title III Information:METHYLENE CHLORIDE IS A TOXIC CHEMICAL
SUBJECT TO THE REPORTING REQUIREMENTS OF SECTION 313 OF TITLE III
OF THE SUPER FUND AMENDMENST AND REAUTHORIZATION ACT (SARA) OF 1986
AND 40 CFR PART 372. YOU MU ST NOTIFY EACH PERSON TO WHOM THIS
MIXTURE OR TRADE NAME PRODUCT IS SOLD. THIS STATEMENT MUST REMAIN A
PART OF THIS MATERIAL SAFETY DATA SHEET. THIS STATEMENT MUST NOT BE
DETACHED. ANY COPY OR REDISTR IBUTION OF THIS MATERIAL SAFETY DATA
SHEET SHALL INCLUDE THIS STATEMENT.
Federal Regulatory Information:MATERIAL SAFETY DATA SHEET: MAY BE USED
TO COMPLY WITH OSHA'S HAZARD COMMUNICATION STANDARD, 29CFR
1910.2100.
State Regulatory Information:NEW JERSEY RIGHT TO KNOW INFORMATION (5
MOST PREDOMINANT INGREDIENTS/HAZARDOUS AND NON-HAZARDOUS) METHYLENE
CHLORIDE CAS #75-09-2; SOYA LECITHIN CAS #8002-43-5.